Once in a while I like to Carving stamps and make a card for my friends
I have been doing this for a couple of years now
Carving stamp is one of my favorite Hobbies
You will need
1. Rubber block
2. Craft knife
3. Carving tools
4. Tracings paper with the design of your choice
Place the tracing paper with the pencil mark side directly over the part of the eraser where you wish to carve the stamp. I use the button, scratch/rub over the lines.
transfer your drawing. Of course, you could also draw directly on the eraser
Cut the carving block down close to your image.
With the carving tool, very carefully start carving the eraser.
Start on the outside lines and leave the inside and details for last.
When the stamp is carved, stamp it on ink.check if you need to make any corrections.
I used a paint brush to clean a little pieces
Done, Now stamp is Ready!
Let's make some card
Comments